Solutions
Quint systems by format, by application and by venue. Every page ends at the same place: send us the room and we model it.
Line array speakers
Stacked point sources fight each other; array modules are designed to couple. The result is controlled vertical dispersion and even SPL over distance, with energy aimed at the audience instead of the ceiling.
Portable line array systems
Compact does not mean cut down. An L10 hang carries the same driver alignment, the same rigging logic and the same target curve as a full L20 rig, so a 200-capacity club and a 2,000-capacity tent are the same system at two scales.
Install line arrays
An install array is not a touring array in different paint. Fixed curvature sets the splay for the coverage the room needs, so nothing shifts between services, seasons or crews and nothing needs re-measuring in year two.
Line array speakers for church
A sanctuary is a reverberant box. Controlled vertical coverage puts the sermon on the congregation instead of the architecture, and that is worth more than any amount of EQ afterwards.
Line array subwoofers
Llow, Lbass and Lsub carry the integrated L-series rigging, so subwoofers fly in the same hang as the modules: one rig, one set of motors, one time-aligned system instead of two that have to be reconciled.
Point source speakers
A point source radiates from a single acoustic centre, so it has nothing to comb-filter against. What you measure at three metres is what the audience hears, scaled — which is why point source systems are so quick to tune.
Column speakers
A column loudspeaker stacks small drivers in one narrow cabinet to narrow the vertical pattern. In a reverberant room with speech program that is exactly the right trade: less energy on the ceiling, more words on the listener.
Beam steering speakers
Split a cabinet into driver sections, give each its own filtered and delayed feed, and the sections sum into a pattern you can aim without moving anything. Change the numbers in the processor, change where the energy goes.
Installation loudspeakers
An install system is judged in year five, not on opening night. Fixed aiming, factory presets and a documented rack mean the system the commissioning engineer signed off is the system the venue still has later.
PA subwoofers
B10 under a bar, B15 and B18 for compact rigs, B21 and Rsub where the floor has to move. The cabinet that fits the space is not always the cabinet the room needs, so we model both before quoting.
Cardioid subwoofers
The B16C pairs a 15-inch front driver with a 12-inch rear driver in a single compact cabinet. The rejection comes from the preset, so there is nothing to align on site and no second cabinet to carry.
Stage monitors
Both wedges are coaxial: low and high frequencies leave from the same point. A performer who steps sideways hears the same tone, which is what ends the "something changed" conversation halfway through a set.
Professional power amplifiers
The A-series spans two to six channels: A23 at 2×3000 W, A42 at 4×2000 W, A4 at 4×1600 W, A41 at 4×1000 W and A6 at 6×500 W, all into 8 Ohm. Switching-mode power supplies with active power factor correction keep the rack light, cool and efficient when the program gets dense.
DSP audio processors
A loudspeaker processor routes inputs to outputs and applies crossover, EQ, delay and limiting per output. Your mix goes in; correctly filtered, time-aligned, protected amplifier feeds come out.
Concert speakers
A concert system has to cover a full house at level without punishing the first ten rows. Flyable modules couple into a controlled vertical pattern, so SPL falls off slowly with distance and the mix stays intelligible to the last row.
Speakers for clubs
Club program is relentless: four-on-the-floor at full level until closing. Quint cabinets are engineered for sustained output, with dynamic limiting tuned to the driver limits, so Saturday sounds like Friday.
Church sound systems
In a service one thing matters above all: intelligibility. Controlled dispersion keeps sound on the congregation and off reflective stone and glass, which is where clarity is usually lost.
Gym sound systems
A class runs at concert level, hour after hour. Quint cabinets are built for sustained output, and the preset in the processor limits them to the driver limits while the energy stays up.
Restaurant sound systems
The trick to restaurant sound is evenness. Many small, well-placed sources at moderate level beat a few loud ones: music everywhere, conversation possible everywhere.
Immersive and spatial audio
In a spatial mix, each loudspeaker position is somewhere an object can be. If the cabinets around the room are not voiced alike, an object changes tone as it travels. One linear target curve across the whole catalog is the precondition for that not happening.
Point source vs line array
A point source radiates from one origin with a pattern fixed by its horn. A line array is many modules coupling into one tall source, with vertical coverage set by hang length and splay. One is aimed; the other is shaped.
Line array vs column array
Both stack drivers vertically to narrow vertical dispersion. A column does it inside one fixed enclosure, usually over the mid and high range only. An array does it with modules you can add, splay, fly and aim per section.
Plan your system with us
Send a floor plan or a rider and our engineers come back with a modelled design: cabinets, amplifiers, presets and coverage.
